The following article is forwarded from http://www.rei.com/expertadvice/ ... +adjusting+fit.html
Once you've selected a pack with the right torso length and hipbelt size, you need to get properly fitted. REI's pack-fitting experts recommend these steps to help you enjoy a comfortable fit every time.
Six Steps to a Great Fit
Your goal is to have 80% to 90% of the load weight resting on your hips. To achieve this, start by putting about 10 to 15 lbs. of weight into the pack to simulate a loaded pack. Follow the steps below in front of a mirror. Get a friend to help if possible, or visit an REI store for more assistance.
Step 1: Hipbelt
First make sure all the pack's straps and hipbelt are loosened.
Put the pack on your back so that the hipbelt is resting over your hip bones.
Close the hipbelt buckle and tighten it.
Check the padded sections of the hipbelt to make sure they wrap around your hips comfortably. Keep at least 1" of clearance on either side of the center buckle.
Note: If the hipbelt is too loose or tight, try repositioning the buckle pieces on the hipbelt straps. If this doesn't solve the problem, you may need a different pack (or hipbelt).
Step 2: Shoulder Straps
Pull down and back on the ends of the shoulder straps to tighten them.
Shoulder straps should fit closely and wrap over and around your shoulder, holding the pack body against your back. They should NOT be carrying the weight.
Have your helper check to see that the shoulder strap anchor points are 1" to 2" inches below the top of your shoulders.
Step 3: Load Lifters
Load-lifter straps are located just below the tops of your shoulders (near your collarbones) and should angle back toward the pack body at a 45-degree angle.
Gently snug the load-lifter straps to pull weight off your shoulders. (Overtightening the load lifters will cause a gap to form between your shoulders and the shoulder straps.)
Step 4: Sternum Strap
Adjust the sternum strap to a comfortable height across your chest.
Buckle the sternum strap and tighten until the shoulder straps are pulled in comfortably from your shoulders, allowing your arms to move freely.
Step 5: Stabilizer Straps
Pull the stabilizer straps located on either side of the hipbelt to snug the pack body toward the hipbelt and stabilize the load.
Step 6: Final Tweak
Go back to the shoulder straps and carefully take a bit of tension off of them. Now you're ready to go! |
发表于 2009-5-30 17:34:00
提升卡
置顶卡
沉默卡
变色卡
抢沙发
发表于 2009-5-30 21:00:28
楼主
